Beha WI-FI Convector Heaters

Beha WI-FI convector heaters are intended for full central heating of the home or can be purchased individually to heat one or more rooms a with a large variety of models available. They are simple to install, user friendly and are double insulated and splashproof making them ideal to use in bathrooms.

Product advantages
System requirements: Wi-Fi router must be set up with 2,4 GHz og WPA2 under installation.
In addition, the heater has the following functions:

Please note. It is important to check that the room intended for the installation of the heater has a strong wifi signal from the router. If not then this can be rectified by purchasing a plug-in wi-fi extender to boost the signal.

Please see our accessories page for a freestanding option.

ITEM NUMBERBeha PV4Beha PV6Beha PV8Beha PV10
Beha PV12
Beha PV15Beha PV20Beha LV5Beha LV7Beha LV10Beha LV12
WATTAGE
400
600800
1000

12501500
2000

500
750
1000
1250

WIDTH (CM)
43.16067.9
80.392.7
117.5
142.3
80.3105.1
129.9
166.9
HEIGHT (CM)
404040
4040
40
40
20202020
DEPTH TO WALL (CM)
8.38.38.38.38.38.38.38.38.38.38.3
CLEAR DISTANCE BELOW
1010101010101010101010
CLEAR DISTANCE SIDE WAYS
2
2
2
2
2
2
2
2
2
2
2
CLEAR DISTANCE ABOVE
1010101010101010101010
VOLTAGE 220 V- 240 V
Front panel’s Surface temperature – Maximum 80°C at 20°C room temperature
Colour – White.
Delivered with 1,5m long cable with plug.
Accuracy of the thermostat – 0,2°C at 20°C room temperature
On/off switch and electronic thermostat
Double insulated
Splash security IP24 (suitable for wet areas)
5 year warranty

Out of stock items will need pre ordering and full payment will be required. Please note, at times there may be a delay in the receipt of orders from Norway especially during the summer months. (please email for more information on delivery time if the product is out of stock) installation is not included or possible when ordering online.

The heater flex cable comes out of the top right of the heater as you look at the heater on the wall. For plug sockets to the left of the heater or not within reach, please purchase the accessory junction box, KRB200. This enables you to extend the cable to a length that is required to reach the socket All of our heaters must be fitted in a horizontal position with the vents at the top. For maximum efficiency all heaters should be fitted with the bottom of the heater 5 cm from the floor when possible. If these guidelines are not followed, a vast amount of efficiency will be lost.
It is the responsibility of the customer to ensure that the electrical supply within the property is sufficient to support the products supplied by Neater Heater.
Please note that some household sockets in Spain and Portugal are not earthed. please check before using or ask a qualified electrician.

Purchases in Gibraltar will need collecting from the MRW office in Línea De La Concepción, Cadiz and may be subject to import duties, payable by the purchaser.

Prices correct as of January 1st 2021.